I used thoses brake for along time and they work very well.

 

Is there a 220mm disk that will fit a marzocchi hub for this setup?

 

We have front rotors but they are not the same bolt pattern as the marzocchi wheel , u may have to run our wheel or try to get ahold of a galfer rotor.
I will have Justin bring home a set and play around with his marzocchi wheel and see what he can find out.

*Bean what mm rotor comes stock on that formula rotor ?

 

Will this setup work for anything other than Zokes?
Say a Red Baron front end possibly?

 

We havent done any testing with the red baron front end , just the fastace and the marzocchis we run. If you can give me some measurements i can let you know

 

Let me know from bolt hole to bolt hole on the fork leg where the brake bolts on

 

Ok will do.

 

here are the brakes being used on johner's old bigminis bike with a formula rotor.

 

here are the brakes being used on johner's old bigminis bike with a formula rotor.

I used them with formula 200mm rotor but I have also use with the Hayes 180mm rotor because it is 5 mm thick compared to the formula 200mm that is only 2.5mm thick. Works well with either rotor. If your able to find a BBR waver rotor then it will even be better because it is 5mm thick and 200mm rotor size. Either way brakes are good and ASV makes a lever for it too

 

Price?

 

[h=1]Just click on the first picture and it brings you right to the site with the part

front brake assy[/h]Complete Brake Systems
(Item no: 2075)

[HR][/HR]

Our Price: $66.89

 

Yup exactly. But the way you did it is close enough

 

thanks for the help johner , have had no issues with these on any of the racebikes here at the shop!

 

Would these work on 04 ktm 65 forks?

 

have not tried them on the ktm65 , check the spacing which should be the same but rotor may be different

 

So you get the caliper, brake line and master cylinder with lever correct? I can use my 200mm formula rotor right?

 

correct!

 

Noticed on Pax Racing that they carry a Formula 200mm Adapter. Would this adapter allow the dual piston caliper to work with my Red Baron forks?

 

You may have to ask johner about the adapter, he would know more about what it would work on. I know these will bolt up to the marzocchi but in your case your spacing looks a bit different as well as the angle.

 

Sorry to bring up such an old thread but do you think this would be a hassle with a joker tornado throttle? Since it is kind of spacious. Thanks

 

nope it should still work fine

 

do you guy still have these in stock?

 

I can add it to may cart so I would say yes