I have a vm26 on my klx and i cant get it to idle. my jetting is damn near perfect at 160/22.5 with clip in the center. i have the idle screw turned to the right as far as it will go and its only open about an 1/8thin and even when i turn it to the left it dont drop much. im thinking something might be jacked up with the idle adjuster. anyone have any ideas?
KSKENE247
Im aware of that. like i said my jetting is basically spot on. i may need to lean the needle out one nothc but its only getting colder so it may take care of itself. i beleive my air screw is right at 1 1/2 turns out.
Just a thought... If you can get the engine to start and "run" with the throttle position past 1/4 open.... Check your pilot jet as it may be plugged or partially plugged.
Actually i think im gonna go down to a 20 moose. i was just messing with it and the more i open or lean the air screw out the more it wants to idle. telling me im to rich down low and it has to much fuel not allowing it to idle. because when i first put it on the tb intake gasket did seal and i was jetting with an air leak so it was acting way leaner then it actually was.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
