Sweet!

 

What is the seat height on this? It's not posted on the website for the 10" but is for the 12"

 

i think its like 30" But i will get seat hght and lenght tmmrw more pics

 

You got me wondering on my klx 110 on what the seat hight was and it was 32inchs lol

 

awesome man!

 

Right on man! You got it and made a thread about it with pics! Excellent, and thank you! Couple questions, did it come shipped like that because they went thru the bike, are they normally shilled in the metal fram with the box? Very nice looking bike. Im actually suprised about the size of the 10" version, I imagined it smaller. Could you take another pic of it with someone on in not strapped down with suspension compressed? Looking forward to this thread and all your input and everything. Very nice lookin 10" Piranha!

 

Nice bike!

Wholesale did a great job on the prep- it's very well put together. The rear shock sock and quarter turn throttle are both nice out of the box upgrades.

Congrats!

HFM

 

yeh i wiill get pics today of seat hieght , an some one sitting on it , and the race prep package didnt come shell'd in metal bc its fully assemlbed from whole sale a non-race prep package will come in box not put toghter,with a metal crate

 

Just an observation, the pipe is blue right there in the pics, the motor must be test run but that is some heat for a new motor to put out, even my worked over 140 does not do that, someone must have beat it hard from the factory.

 

Pipes heat more when they are sitting, no air to cool them...

 

Sweet man, looks good! Damn I can't wait! I love the little detail, shock sock, air filter sock, cable tie on the rear brake lever! That's cool man, good quality from what I see. Congrats brotha.

 

I let it run for 2 hours 30 min on an 30min off too cool down to break it in ,and riding the bike , nice and easy to break her in, it's stainless steel exhaust that is polished , it will turn blue easer then non coated exhaust, it wasn't blue when I got it I checked , and running it at idle will make it turn blue any race 4 stroke motor

 

I let it run for 4 hours 30 min on an 30min off too cool down to break it in ,and yeh I was ripping the bike around before I took the pics , it's stainless steel exhaust that is polished , it will turn blue easer then non coated exhaust, it wasn't blue when I got it I checked , and running it at idle will make it turn blue any race 4 stroke motor

You let it idle for four and a half hours to break it in? Still, my race 140 has never made that much heat either idleing or sitting.

 

Seat height is 30"
WheelBase 45"

 

Seat height is 30" WheelBase 45"

How do you measure wheel base like axel Bolt to axel bolt or the front of the front tire to the back of the rear tire

 

I was off with the tape measure up on the front axel had no one to help but it's 45" for a fact, u can do center of axle bolt

 

What's the ground clearance on the 10"?

 

What carb did it come with?

 

22mm mikuni I'm gonna put a 28 or 26 mm on it

 

Ok im running a 26 molkt. On mine but im thinking about switching to a 26 mikuni because my bike hasnt ran right since i crashed last time

 

i had it on choke for 5 min to warm up bc it was like 17 degress out side, it was reving madd high after it warmd up on choke,i left to go into the office , came walking back in the shop to turn choke off so it would idle and pipe was red , its normal it will happen , it was turning red bc it was on choke and the engine was running rich bc it was on choke at a high rev and it turns red hott , any race 4 stroke , or high reving 4 stroke will get red hott on choke easyyyy

 

I'm sure Wholesale Cycle will take note of your break-in procedure. You don't let an aircooled motor sit in one place at a high idle with the choke on and walk away. No wonder the header was red hot.

 

Come to ny and show me how it's done please bc I see your in SoCal.

 

Smokin deal on the bike! In one of your pic's, the subframe look's tweeked to the right,or is just the picture angle?

 

HELLO are you not reading the post! it was 17 degrees out and it was cold out I left it on choke bc if u start it and shut choke off its Ganna stall out if you have a better start procedure please share it with me

 

1) Start and warm up the engine. Check Idle speed, then check engine stop switch. Restart engine within 5 minutes.
(Im assuming let engine cool)
2) Restart engine, operate through lower gears for 5-8 minutes.
(Again assuming let engine cool)
3) Restart and check how the machine is ridden with the throttle 1/4 to 1/2 open for about an hour.
(Assuming let engine cool)
4)Restart engine and check all gears and operate for 10-15 minutes.


Thanks in advance!
Too ....234wheeler in SoCal. What's coldest it gets 60 degrees

 

have you rode it yet? Curious how well it handles and how the power is. I know its hard to review it with it being winter and crap weather lol.

 

The power is great , it feels like my 250f just smaller, nasty low end and mid range , it just keeps pulling in corners the power is there when you want it

 

I don't think he has, he has no clue what he is talking about, I bet it's some 16yr old kid Behind that computer. just running his mouth

 

3-4 motos before we actually race there getting warmed up. aint no start and go here. congrats on your purchase, been a while since i rode the 140 but suprised of the power it had

 

3-4 motos before we actually race there getting warmed up. aint no start and go here. congrats on your purchase, been a while since i rode the 140 but suprised of the power it had

what are you riding these days ?