[cernicky381]

Anyone have an idea I it will work?

 

[cernicky381]

No one?

 

[hokoman]

Sounds like it would take a lot of custom work. The old forks works on z50s with a tb triple, but the head tube is longer on a ct70.

 

[cernicky381]

All for a custom build but you are saying that I'd need to make my own stem between the two clamps?

 

[Fall_Guy]

Interesting thread, I was just about to post a similar question. I want to mount a set of KLX size inverted forks on a CT70 (zokes or fast ace). As of now, I cannot find a triple clamp that will mount to the fork tubes (45mm top clamp 48 mm bottom clamp) and has a compatible stem that fits the CT. A custom stem may be the only option, but I haven't figured out the stem size yet.

I would be interested to know what you figure out.

 

[cernicky381]

I am going to measure up the stock clamps from a 110 as far as spacing, then buy some aluminum and mill the bottom, and top clamp the n lathe out the stem

 

[cernicky381]

Is it possible to press out the stock stem out of the bottom clamp?

 

[Fall_Guy]

I would think yes, but I have never done it. Lots of tech guys on here that could probably answer this, but seems like we can't get their attention.

Is it possible to press out the stock stem out of the bottom clamp?

 

[fiddyrider78]

heres a pic. of one

 

[Fall_Guy]

What is the length of the forks (center axle top) that you intend to use? I don't know what stock KLX fork lengths are but the zokes or fast ace are 730 mm.

I want to run a "12 wheel similar to the Grom, but I'm concerned about the clamp spacing of the fork tubes being too wide or too narrow to for a 12" wheel.

Even if I press the stem I still have to decide on KLX or CRF triple clamps depending on the tube spacing for the wheel.