Clean the carb and then try it.

 

New oil and gas ?

 

yeah, I also planned on changing the oil. We also turned the bike upside down and kicked it cause I have heard that helps to get the water out, any way, some oil drained from the breather hose and it looked fine, wasn't milky or anything. Still, I am gonna change it.

 

yea id change the oil and gas and clean the carb...

 

Pull the pipe off . Maybe there is water in there too ?

 

check your electronics!

 

clean out the carb. if you didn't completely dry your airfilter then it probly sucked more water into the carb. the oil should be fine.

 

check your electronics!

pretty sure that they are good. Like I said, the bike runs

 

pretty sure that they are good. Like I said, the bike runs

After washing my 110 one time a little bit of water got in my spark plug cap and the bike would not run right till I got it dry.



So I would check that and your other electric stuff since water can short stuff out.

 

put some marvel mystery oil in it, helps clean it out

 

I would try the old method of taking everything apart, cleaning it, and then put it back together. I'm sure that will fix it.

 

clean air filter and make sure not to much oil, and clean valves i did the same thhing not to long ago.

 

check the gas tank

 

It wouldnt hurt to clean or change the spark plug as well

 

yeah, I changed the plug but no luck. About that mystery marvel oil, just do an oil change with this stuff of what? I have heard of it before but wasn't sure what it's purpose was.

 

OK, so I pulled the ignition cover off and there was oil in there. Is this bad? I know the 50's are bone dry, which is what I would assume the case for 110's would be. Now what?

 

yeah, I changed the plug but no luck. About that mystery marvel oil, just do an oil change with this stuff of what? I have heard of it before but wasn't sure what it's purpose was.

Here is all you need to know about Marvel Mystery oils .



::Marvel Mystery Oil::

 

OK, so I pulled the ignition cover off and there was oil in there. Is this bad? I know the 50's are bone dry, which is what I would assume the case for 110's would be. Now what?

The 110 flywheels are always submerged in engine oil .

 

OK, so I pulled the ignition cover off and there was oil in there. Is this bad? I know the 50's are bone dry, which is what I would assume the case for 110's would be. Now what?

on a 50 the stator is sealed on a 110 it is not. oil goes in there to lube the cam chain.

 

Hmmmm good to know. Thanks guys.

 

down to the electric part, like I said, the bike would idle, but that was all. Now it won't run at all so I checked the spark. None, what should I do / check now?

 

OK, so I started cleaning out all the plugs, one by one. After doing the plug for the bump start thing it started back up, but still only idles. Should I go back to the carb process or could it still be electrical?

 

am I screwed?

Temporarily, yes.

 

Yes check the fuel system then go on to the electrical system or vice versa.



Fresh gas. Fresh oil. Dry all the electrical connectors.