PlanetMinis Forums banner
1 - 10 of 10 Posts

j440

· Registered
Joined
·
1,618 Posts
Discussion starter · #1 ·
can you get to neutral between 1st and 2nd gear? my friend told me you can when i asked him how you get a decent start on a clutchless 110.



my 110 is under construction right now so i can't go find out
 
ive done it before but thats bc im stupid on my stocker...going from 3rd pinned to slapping it back into 1st as i enter a turn ahahhaa...hints why i have to have it rebuilt..and on starts im the last person to tell u how to start, i can start a stocker to save my life. and make sure u keep oil in it and change it often! ahahhah
 
He's probably referring to holding up on the shift lever when you shift. When the lever is up it temporarily disengages the clutch and you can rev the bike up before you release the lever. This is pretty hard on your tranny and clucth though.
 
Discussion starter · #7 ·
bt260 said:
He's probably referring to holding up on the shift lever when you shift. When the lever is up it temporarily disengages the clutch and you can rev the bike up before you release the lever. This is pretty hard on your tranny and clucth though.


ya i think thats what he meant.



i have a clutch on its way though:D
 
j440 said:
ya i think thats what he meant.



i have a clutch on its way though:D




Think about getting a primary drive gear too, the extra mass you take off the crank really makes a difference in how the bike revs. I think I've seen a few used ones in the classifieds here for under $60. I love mine.
 
LOL, yah u can. If u r in neutral u can just click up into first and hold it there twist the trottle till the gate drops and let it go. Its not the best thing to do because its like dumping the clutch and it wears on yur clutch in the engine but it works. Or u can just go striaght up to 2nd and step down on the shifter and then when the gates drops step off the shifter.
 
1 - 10 of 10 Posts