PlanetMinis Forums banner
1 - 5 of 5 Posts

dant50

· Registered
Joined
·
14 Posts
Discussion starter · #1 ·
I have the following stock parts for sale

- motor, with about 30 minutes off run time and scratches on the left side

cover where it slid across the parking lot on a small spill. $550obo

- swingarm, like new except for scratches on the back left side same

spill as motor. $50 shipped

- carb airbox manifold, like new. $50 shipped

- shock, 30 minutes of ride time. $35 shipped

- gas tank, brand new in box. $60 shipped

- petcock, brand new in box. $25 shipped

- front wheel, 30 minutes of ride time comes with tire. $120 shipped

- cdi, 30 minutes run time. $30 shipped

- front brake panel, 30 minutes use with pads. $30 shipped

- muffler, 30 minutes use small scratches on the very back. $120 shipped

The following parts are for a crf50 but are not stock

- 10" billet wheels from motard 50's they are the 2 and 3 inch wide wheels

they are black and are set-up for marzocchi front and drum rear i believe

you can still get new hubs for a different set-up they are like new except

for 1 scratch on the rear wheel they have about 2hrs ride time on them

and come with hideneau tires. $650 shipped obo

- 24mm keihin pe24 carb, 3hrs. of use. $150 Shipped

The following is a 2005 crf50 for sale

- pro-taper bars

- asv clutch lever

- marzocchi 35mm forks with 3 different sets of fork springs and extra shims

- elka rear shock with 3 different springs

- 12" hd front wheel

- ahp stage2 motor with an extra piston and cylinder and lightened flywheel

the piston in it now is a 52mm high compression piston as opposed to the

flat top 51.4mm piston that comes in it from ahp.

- 20mm carb with both foam and paper filters

- two brothers extended swingarm and chain guide

- tall gripper seat

- minigunz pipe

- trail bikes rev box

- DID gold chain

- has stock rear sprocket but includes an extra cold fusion 35 tooth sprocket

- green and black plastic in like new condition except where my pipe melted to

the right rear number plate it is also on the pipe

- stock frame, rear wheel, coil

This bike has about 4 hrs of ride time on it and has been maintained meticulously. I have changed the oil 4 times and have checked the valves 3 times also. The motor was broken in with heat cycles as well as the new top end.

Please make offers

I am working on pics for these pm if interested
 
1 - 5 of 5 Posts