no longer showing builds
xr 80/ klx 110 mutant motor
storminnorman07
1 - 20 of 86 Posts
Joined
·
3,191 Posts
no longer showing builds
Joined
·
1,673 Posts
awsome man..ive been waiting for this thread.
Joined
·
5,276 Posts
cant wait to see the bike when its all done!
Joined
·
3,191 Posts
no longer showing builds
my last post wasn't very clear.
I mean how would you make the cut down the center for splitting the cases?
Milling I guess? It seems like the cut would have to very very precise and even to keep an equal gap with the rest of the cases, make sure the center gasket seals well.
I mean how would you make the cut down the center for splitting the cases?
Milling I guess? It seems like the cut would have to very very precise and even to keep an equal gap with the rest of the cases, make sure the center gasket seals well.
Joined
·
3,191 Posts
no longer showing builds
Joined
·
3,191 Posts
no longer showing builds
Joined
·
3,191 Posts
no longer showing builds
Joined
·
1,773 Posts
Now this is cool. Awesome to see some solid fab work!
Joined
·
1,773 Posts
Quick question though, do the XR80 motors have a motor mount bolt that go through the head? Or is it a plate that connects the cylinder/head to the frame?
Just thinking outloud here. Can't wait to see the final product.
Just thinking outloud here. Can't wait to see the final product.
Joined
·
16,707 Posts
Most of the series (I thought all, until recently) doesn't use any head stay. Only the late XL100 had one.
Nice work , Chad. You can ditch the sling plate, if you situate the pin just right, allowing a lot more to come off the right half if looking for a real light setup. 195cc may not want it, though. lol
Be careful pressing the crank back together, as the offset part of the pin is not as wide as the rod, usually. With the 6mm offset, weld a pair of tacks on each end once it's trued up. Or DIDN'T you fire your crank guy for being too slow?
Nice work , Chad. You can ditch the sling plate, if you situate the pin just right, allowing a lot more to come off the right half if looking for a real light setup. 195cc may not want it, though. lol
Be careful pressing the crank back together, as the offset part of the pin is not as wide as the rod, usually. With the 6mm offset, weld a pair of tacks on each end once it's trued up. Or DIDN'T you fire your crank guy for being too slow?
Joined
·
1,773 Posts
firepower354 said:
Doh, spoke too soon!
Joined
·
824 Posts
Is that enough bearing to support that much uumph?
Joined
·
16,707 Posts
theraymondguy said:
Other popular pit bike engines in that size range use a very similar bearing.
Joined
·
3,191 Posts
no longer showing builds
Joined
·
3,191 Posts
no longer showing builds
1 - 20 of 86 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
