PlanetMinis Forums banner
Cancel
Create thread New Forums

how much chain slack (about) do you have on your 110's

Jump to Latest
1 - 12 of 12 Posts

ace57

· Registered
Joined
·
64 Posts
Discussion starter · #1 ·
hey guys about how much chain slack do u run in your 110's...

like if you measured half way in between the sprockets, about how many inches up would it go....no i'm not ocd:rolleyes:





ace57
 
#6 ·
Sorry im bringing up an old thread.....(better than making a new one)



When you guys say 2 fingers between the chain slider and chain, are you guys measuring to the very beginning of the slider by the smaller sprocket.



Also with what T-Bolt said....is it 1" down and up measurement from the center of the swingarm (aka distance bt bolt on the swingarm bearing and axle bolt)
 
#11 ·
Marnes2986 said:
for the 1" slack or for the 2 fingers on the slider?
Click to expand...


Both, you want your weight on the bike since if you set it when the bike is on the stand and then sit on it the chain will be tight then. The way i do it so im not tring to sit on the bike and check it is loosen your rear wheel and take a 10mm wrench and put it between the chain and sprocket and actually roll the wrench up in the chain and sprocket. This will also pull your wheel tight against your adjusters. I roll the wrench in there and set the chain with no slack then tighten the axle and roll the wheel forward to get the wrench out and mines set perfect everytime. Makes it alot faster then the two finger method.
 
1 - 12 of 12 Posts
About this Discussion
11 Replies
9 Participants
Last post:
rmc217
PlanetMinis Forums
posts
2.1M
members
63K
Since
2003
PlanetMinis forum is the internet's largest mini bike community. View thousands of photos, event coverage, tips, tricks and performance mods.
Full Forum Listing
Explore Our Forums
CRF50 KLX110, DRZ110, TTR90 Chinese/Import Minis - General Discussion Z50, CT70 and JDM Monkeybikes Complete Bikes For Sale - All makes and models