Sourcing Question - Anyone know where to find this??

z50 chopper

· Registered

Joined Jun 29, 2009

·

1,458 Posts

#21 · Jul 20, 2009

Only show this user

oops didn't realize that the engine area that is to be drilled was aluminum, I am still very new to minis.

In that case I think that engine part being drilled should be taken off and then drilled.

 

G

goldenboy81

· Registered

Joined Dec 8, 2008

·

65 Posts

Discussion starter · #22 · Jul 20, 2009

Only show this user

Finally found it thanks to Dirtbkr188 (he directed me to a good site which ended up having it in steel not Aluminum). This is the only site on the planet Earth that carries it if anyone else ends up needing it. Will be easier than retapping the holes.



Click Here