PlanetMinis Forums banner
Cancel
Create thread New Forums

Are these cases salvagable? Pics inside

Jump to Latest
1 - 10 of 10 Posts

ducatilover

· Registered
Joined
·
936 Posts
Discussion starter · #1 ·
I split the cases on an xr50 motor I had bought (for parts) because there was somethign rattling inside. Turns out there was a bolt in the case (i have no idea where its supposed to go or where it came from). There are also two holes in the cases and I was wondering if they could be fixed (JB weld??). What do you think? The first is located where the kickshaft rests (or where the screw that holds the flywheel cover screws into) and the second is located where one of the footpeg bolts screws into on the clutch side.

Image


Image
 
#3 ·
Clean the area real good with contact cleaner to remove the oil residue, and take it to a welder, and have it done right. You can then dress up the area by the kickstarter spindle with a dremel.
 
#6 ·
Why not just find some clean cases?
 
Save
Reply Quote Like Like
#8 ·
Engine cases are super hard to weld. Hopefully he is really good at welding. I have only really seen points cases or bored cases for sale. I have 2 sets of points cases, but I really need a set of cdi cases as well.
 
Save
Reply Quote Like Like
1 - 10 of 10 Posts
About this Discussion
9 Replies
5 Participants
Last post:
s_10onbagz
PlanetMinis Forums
posts
2.1M
members
63K
Since
2003
PlanetMinis forum is the internet's largest mini bike community. View thousands of photos, event coverage, tips, tricks and performance mods.
Full Forum Listing
Explore Our Forums
CRF50 KLX110, DRZ110, TTR90 Chinese/Import Minis - General Discussion Z50, CT70 and JDM Monkeybikes Complete Bikes For Sale - All makes and models