PlanetMinis Forums banner
1 - 13 of 13 Posts
Discussion starter · #4 ·
heres a pic of it. I know its missing the bearing that sits in the basket i was looking for it as i took the picture and found it. Id like to also note that when i took it off, i had to cut lines in the screws that hold the plate on So it makes them easier to come off. There are very small cut marks on only two of the top plates screw holes, but doesnt affect the clutch or durability what so ever. Im seeing if i have another plate and if i do ill throw that in instead Also it comes with a gasket as its stuck to the back of the cover and has no tears so you will easily be able to throw it on and ride.



Image
 
Discussion starter · #7 ·
2 plate, and i can try and find a cable but this motor came off the shelf from sitting so there wasnt a cable on it. I always run KX80 or 85 clutch cables as they have a metal spring around them at the bottom so its perfect to be close to the pipe.
 
super good deal! and i asked tb a while back and they said you can put the 3 plate kit in these and have a 3 plate clutch... or maybe he was saying you can use 2 out of the 3 but thats not what i understood
 
Discussion starter · #12 ·
alright sweet, btw i found the other cover that goes on the basket, so it wont have any cut marks on the clutch which is mint. keep in mind to for 15 bucks from TB you can make this a 3 plate clutch kit. As thats what i did for my 88 motor.
 
Yeah, I'll probably use the current plates until they are worn and then buy the three plate upgrade. No point in throwing away perfectly good stuff. I'm about to reply to your PM. Thanks man. I'll continue to communicate through PM's.
 
1 - 13 of 13 Posts