PlanetMinis Forums banner
Cancel
Create thread New Forums

z50 engine stand?

Jump to Latest
1 - 13 of 13 Posts
X

Xrmini2

· Registered
Joined
·
30 Posts
Discussion starter · #1 ·
I been looking for a engine stand for my z50 motors. Has any one used one of these from AHP??





Ahp Minis





I am assuming these work with most 50 motors just curious if my older z50 motor will go in. Also if any one seen others let mek now,
 
#9 ·
The stands are awesome, you can fit drain pans under them, you can flip the engine vertical or horizontal. Albeit a bit expensive, if you plan on working on your engine(s) a decent amount over the years its worth the initial investment. I have had the same ones for 4 years also, so they hold up as well and will fit any engine with the Honda motor mount, which includes YX engines.
 
#10 ·
The one AHP is selling is probably the nicest to use out of all of them. I wouldnt trust that vice stand unless you have a really strong vice. Lot's of leverage going on there once you start wrenching.
 
1 - 13 of 13 Posts
About this Discussion
12 Replies
9 Participants
Last post:
AHPminis
PlanetMinis Forums
posts
2.1M
members
63K
Since
2003
PlanetMinis forum is the internet's largest mini bike community. View thousands of photos, event coverage, tips, tricks and performance mods.
Full Forum Listing
Explore Our Forums
CRF50 KLX110, DRZ110, TTR90 Chinese/Import Minis - General Discussion Z50, CT70 and JDM Monkeybikes Complete Bikes For Sale - All makes and models