PlanetMinis Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
383 Posts
Discussion Starter · #1 ·
I know I've read this here in the forum before, but I can't find it....



How do you replace the stock throttle cable on an early Z50A? The carb side is dead simple, I need help at the throttle end.



Rob.
 

·
Registered
Joined
·
383 Posts
Discussion Starter · #3 ·
The answer is:





Remove kill switch (If on right handle bar)

Remove rubber throttle grip

Remove grip set screw (small, underside of bar, close to brake perch)

Remove throttle grip pipe

Remove throttle wire hinge

Remove throttle cable holder (base of throttle cable threads into this)

Remove throttle cable grommet from bar

Pull cable through handle bar



Installation is reverse.



After sorting through this, it appears my new cable has about 1/2" too much jacket (not exposing enough cable). The fun never ends!
 

Attachments

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top