PlanetMinis Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
Finally getting around to putting this bike back together…

I have an issue with the choke. When I assemble the choke and insert the lever through, there is a ton of play between the choke valve and choke link, and the link falls out and disconnects from the valve. I do not see any other parts on the parts diagram, and don’t recall removing any parts.

Does the link need to be bent a bit more in order to retain the choke valve?

Hand Camera lens Finger Engineering Thumb

What am I missing?
 

·
Registered
Joined
·
1,409 Posts
I think you just need to push the lever further in...do you have all of the washers and spacers etc for the threaded end?
 

·
Registered
Joined
·
22 Posts
Discussion Starter · #3 ·
Thanks kirrbby!! Fixed in 2 seconds. It would be something obvious like that :rolleyes:

And thanks again for the choke valve … that’s your valve I’m installing.
 
1 - 4 of 4 Posts
Top