PlanetMinis Forums banner
1 - 13 of 13 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
I been looking for a engine stand for my z50 motors. Has any one used one of these from AHP??





Ahp Minis





I am assuming these work with most 50 motors just curious if my older z50 motor will go in. Also if any one seen others let mek now,
 

·
Premium Member
Joined
·
5,014 Posts
The stands are awesome, you can fit drain pans under them, you can flip the engine vertical or horizontal. Albeit a bit expensive, if you plan on working on your engine(s) a decent amount over the years its worth the initial investment. I have had the same ones for 4 years also, so they hold up as well and will fit any engine with the Honda motor mount, which includes YX engines.
 

·
Registered
Joined
·
5,831 Posts
The one AHP is selling is probably the nicest to use out of all of them. I wouldnt trust that vice stand unless you have a really strong vice. Lot's of leverage going on there once you start wrenching.
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top