PlanetMinis Forums banner
1 - 1 of 5 Posts

· Registered
19 Posts
Discussion Starter · #1 · (Edited)
I've got a 1987 YSR50. Stock bore, tcr exhaust, mikuni/sudco carb with k&n air filter. After cleaning the carb, it starts, idles and runs beautifully, but at high rpms, it cuts out and stutters almost like a rev limiter sometimes. Does it at a standstill and when riding under a load. Can accelerate pretty well but it really seems like when I give it over 85% throttle or so it just wants to break up. If you baby it and get to higher rpms, it cuts out until you reduce the throttle then it picks up again. Tried adjusting the air fuel screw with little to no difference, and the needle being in the middle clip seems to be best, one clip up(more fuel) and it breaks up at a much lower rpm/throttle, and one higher clip(less fuel) and it seems to be worse then original position in the middle. Any ideas? Running a b9hs. Also running premis and oil injection just to be safe(bike is new to me,didn't trust the injection) Thanks in advance!!


1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.