PlanetMinis Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
472 Posts
Discussion Starter · #1 ·
Yoshimura TM-MJN24, 26 or 28mm for Big Bore?



Lets say any motor (140cc, 150cc or little large) or your favorite 143cc Takegawa Lady Killer.



Which carb would be choice? Let's say down the road you plan on cam'in a little bit etc.



Which of these carbs would be the best investment?



Thanks



Muxster
 

·
Registered
Joined
·
9,515 Posts
It depends. On a high-compression 143+ I'd run a 26 or bigger.



The TM-MJN24's for street apps, I'd run on a well built 88 or 108.



My official answer is it depends on the engine combination, the exhaust, street/dirt and a number of other factors. Good head, cam, etc.
 

·
Registered
Joined
·
472 Posts
Discussion Starter · #8 ·
gstegman said:
32mm carb on a 125? :nono:




I was thinking the same thing..



Brad Renyolds chime in please!



Im thinking 26mm. I am think about most usability for a long period of time on various motors if needed. I think thats called an "Investment."



The price is $490.00 for the 26mm



I dont plan on ever running a motor smaller than 143cc or larger than 180cc
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top