PlanetMinis Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
89 Posts
Discussion Starter · #1 ·
will a xy160 chage a batt out of the box or do u need some thing else some guy told me i wood have buy high output stator so it could chage the batt but its a motovert rx with a jailin 125 in it



thanks adam



 

·
Registered
Joined
·
301 Posts
realmenride50s said:
will a xy160 chage a batt out of the box or do u need some thing else some guy told me i wood have buy high output stator so it could chage the batt but its a motovert rx with a jailin 125 in it



thanks adam







It will be enough power w/ a standard flywheel and stator.



I put this TBolt USA, LLC » Pitbike Engine Parts » Electrical » 12V CDI SYSTEM KIT on my YX150 (the motor came stock w/ a inner rotor) and it runs the light and charges the battery on my Baja Design kit just fine. I think the flywheel and stator (from Tbolt's kit), are the same as what would come on a YX150 or YX160 w/ a standard flywheel setup.
 

·
Vendor
Joined
·
41 Posts
Some companies sell the YX 150 and 160 built with a lighting coil that should power your battery just fine. The GPX 160 comes with a high out put lighting coil in it but I think you should look into a Lifan 150 for street legal use and put your stock stator and flywheel on it. IT will bolt up with your pipe, and intake easier. The trans ratio is rad for street riding.
 
1 - 3 of 3 Posts
Top