PlanetMinis Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
Ok so I want to know what you would have to do to do this.... I dont want to hear about how it's a waste of time and money that it's pointless or that its to big job and can't be done because I've already seen people that have done it I just want to know how its done. What has to be cut what has to be welded what mounts have to be replaced what all would you have to have for the swap....... I don't insolvent anything about the motormounts on an xr200 all I know is that the engine looks to be a bit taller
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top