PlanetMinis Forums banner
1 - 16 of 16 Posts

· Registered
Joined
·
10,051 Posts
Discussion Starter · #1 ·
Found out about some new parts today. This is all the info I have, so don't ask me to answer questions...



4V single cam head, with 52mm cylinder. Don't know where to purchase it, don't know how much, and don't know how well it will run...











Let the debate begin...
 

· Registered
Joined
·
4,543 Posts
guga...guguh...gugak..gimmik!

see what i dont get is why, for fun and money? hey lets make a DUAL EXAUST PORT 4V TRUE DUAL EXAUST HEAD!

i dont think this would help much becuse its what a 52mm bore?

for a 100mm bore rock on!

:lol:
 

· Registered
Joined
·
10,051 Posts
Discussion Starter · #7 ·
To be honest, with a single cam and 4 valves, I don't see this performing much more than a good 2V head. I also don't think these parts are going to be very expensive. Probably cheaper than the Takitaco parts. I make no judgement until I can see the parts perform in person.



Dan
 

· Registered
Joined
·
87 Posts
in theory it should be dope, but you will never know, until someone throws it on a flow bench back to back with a 2v head. if the ports are designed right it should should out flow a p+p'd 2v. its not an anomoly that all the sweet 4poppers out there are 16v, and 20v. i'm also talking flow carictarisics, it wont turn your 88 in to crf 450.
 

· Registered
Joined
·
567 Posts
five0addict said:
guga...guguh...gugak..gimmik!

see what i dont get is why, for fun and money? hey lets make a DUAL EXAUST PORT 4V TRUE DUAL EXAUST HEAD!

i dont think this would help much becuse its what a 52mm bore?

for a 100mm bore rock on!

:lol:


ya... you know, cuz two exhaust valves means dual exhaust ports
 
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top