26 if you want low end tight tracks and 28 for high speed stuff
vm26mm or 28mm flat side on 124se?
I am trying to decide what carb to run, I have the vm26mm on my 124se, have the inner rotor and kitaco clutch and runs very strong, I know the mikuni 28mm flat side is harder to tune but what kind of gains or losses could be expected? I dont want to lose any tourqe, but I have been told that the 28mm flat side would have much faster acceleration.
has anybody done a comparison?
has anybody done a comparison?
1 - 7 of 7 Posts
go with the 26mm. Its much easier to work with and way more reliable
i have a 28mm laying around im not using if ur interested.
Never a flat slide! if your going to run a 28mm make it a D slide 100 times better!
is the d slide really that much better? Im still trying to bebate taking the 26mm off becuase its so tourqey, have you guys had trouble jetting them? and what jetting did you guys end up with, Thanksibmike13 said:Never a flat slide! if your going to run a 28mm make it a D slide 100 times better!
Lupo
1 - 7 of 7 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
PlanetMinis Forums
PlanetMinis forum is the internet's largest mini bike community. View thousands of photos, event coverage, tips, tricks and performance mods.
Full Forum Listing
