Valve clearance for Takegawa 88cc kit question

2487 Views 5 Replies 2 Participants Last post by fiddycent, Apr 7, 2004

fiddycent

Discussion Starter · Apr 7, 2004

I'm confused. The directions tell me that I should gap the valve @ .05 but then says that there should be no valve clearance.

Which one do I believe?

Thanks

Save

1 - 6 of 6 Posts

· #2 · Apr 7, 2004

adjust them to .05mm.

Save

fiddycent

Discussion Starter · #3 · Apr 7, 2004

So I gap it with .05 then it says to spin the rotor twice then check gap again, if there is no gap it's done right?

How can I gap it spin it then it comes back with it no gap?

Save

· #4 · Apr 7, 2004

Forget the part about it saying there is no clearance.

Save

SkunkwerxKen

· #5 · Apr 7, 2004

setting gap

set gap @.05 turn rotor twice then simply check that your gap gauge isnt

to loose or to tight if either or happens reset the gap and check again.

Save

fiddycent

Discussion Starter · #6 · Apr 7, 2004

Thanks guys, I'll do that.

Save

1 - 6 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month