PlanetMinis Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
So I was wondering if I could just take a ttr90 engine and put it in my ttr50. Looks like it’s going to be impossible to find a big bore kit but I have a ttr90 engine I could use. But has anyone else done this? I know I will most likely have to weld some new mounts but just curious. Any advice would be appreciated!
 

·
Administrator
Joined
·
11,380 Posts
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top