PlanetMinis Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
892 Posts
Discussion Starter · #1 ·
I took the rockers and valve adjustment nut and screws from the 79 z50 head I recently got and put them on my xr50 head. With the valve adjusters all the way in, there is still a lot of clearance between the valve springs and rockers. Could it be that the cam is out of spec?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top