PlanetMinis Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
I recently swapped the handlebars on a 1978 Z50A and noticed that the aftermarket throttle grips do not offer the same range of motion as the stock. What I mean by this is if I have my knuckles at 12 on the throttle and I go wide open my knuckles are now at maybe 1:30. Is there a workaround for this? Nothing is binding as I have pulled the intake off of the carb and the throttle valve is moving freely up and down with full range.
 
1 - 1 of 1 Posts
Top