PlanetMinis Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
Thinking about upgrading to an 88cc kit in the near future.



What other items do you suggest to upgrade to the motor/tranny to accomodate the increase in horsepower. My bike is mostly stock when it comes to the motor and tranny. I've got a 62 main with a Uni POD filter.



Going with the following:

TB 88cc Big Bore kit, 20mm Carburetor kit, and Race Cam Performance Kit

TB High Volume Oil Pump
 

· Registered
Joined
·
12,757 Posts
youll need all that you listed with the addition to HD clutch springs if your a big kid. if your around 100lbs then you should be fine for a while.



so basically just beef up the clutch a little bit and your good to go. this isnt neccesarry for the 88 kit to work but the extra horespower will wear the clutch out faster than the stocker would....alot faster :D
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top