PlanetMinis Forums banner

studding tires

933 Views 6 Replies 5 Participants Last post by  1shiftaway
Ok guys, I just got my tires today and I studded the rear one up. It looks good. I am using Michlein Starcross MS2 front and rear. Anyways my question is, what can I put as a protection barrier between the inside of the tire and the tube? I made sure none of the screws came through but I don't want them to tighten up or punture the tube if I hit hard. You need to have some good traction up here if you are going to make it through the 38 inches of snow we have and maybe another 14 more to come. If anybody has any ideas please feel free to share your ideas.

Thanks,

Fireball929[/quote]
1 - 7 of 7 Posts
hi

you can cut up an old tube and lay that in there,then put in the new tube that will give you an extra layer of rubber and run 2psi more than normal that should work fine! thats what ice racers use!

R.j.perez
Hey Fireball what kind of studs r u using. We r using the same tires with 1/2 inch holiday racing studs and we dont run aliner u just gotta angle them right
how much are the holiday studs and where can i get them

thanks in advance
Hey guys, I will take your advice on the old tubes. I went to a hardware store and bought 6 or 8 by 1/4 hex head machine screws. I just finished studdeding them and ended up with 180 screws in each tire. I didn't have one go through at all even on the side lugs. Now only if it stops snowing and everything can freeze a little more I can try them out. I will post pics when I install them.

Thanks,

Fireball929
smoothkustard said:
how much are the holiday studs and where can i get them

thanks in advance
$30.00 cdn. for 500 studs,phone #905 725 5964 ask for Mark
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top