PlanetMinis Forums banner
1 - 20 of 24 Posts

·
Registered
Joined
·
616 Posts
Discussion Starter · #1 ·
I heard there are dimensions of the str adapter to run a front disk break setup? Few questions about them.
Has anyone built one from said dimensions?
If so, what was the break system?
Thanks for reading. All intel is appreciated
 

·
Registered
Joined
·
1,042 Posts
The str adapters were made to adapt a kx65 front or rear caliper to your bike. Most guys used or use a front adapter a kx65 front caliper kx65 master cylinder a custom brake line and a asv or aftermarket lever. The kx65 brakes allow you to run galfer rotors or larger brake rotors. The str adapters go on zoke fork setups. They also made a rear adapter also. I've never used a rear adapter before so I have no knowledge about them.
 

·
Registered
Joined
·
8,247 Posts
just know he works a crazy work schedule but eventually gets back to people over time.
 
1 - 20 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top