PlanetMinis Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
3,787 Posts
Not totally sure but I beleive you can press them out of hammer them out. I think you have to replace them with new ones afterwards though.
 

·
Registered
Joined
·
4,688 Posts
First of all, they are chintsy bushings not bearings. I would say that they would have to be pressed out. I tried pressing my stockers out with a bench vise and a socket that just barely fit inside the tubing of the swingarm. Definately didn't work. Might have to heat it up??
 

·
Registered
Joined
·
2,902 Posts
Discussion Starter · #4 ·
I aint worried about it, could i still powdercoat it with the bushings in there? shouldn't hurt them I wouldn't think, since they don't do anything really anyways
 

·
Registered
Joined
·
5,829 Posts
- I think the heat of powder coating may damage the bushings ??

- Parts Unlimited had a listing in their catalogue for a bearing convertion kit from a company called Pivot Works .
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top