PlanetMinis Forums banner
1 - 11 of 11 Posts

·
Registered
Joined
·
4,829 Posts
It opens it up a little. The stock needle is tuneable, run the clip in the middle.
 

·
Registered
Joined
·
79 Posts
You can take the whole choke flap an shaft out. Just use some JB weld to fill in the holes or some apoxy. Another thing you can do is use some apoxy to smooth out the intake of the carb so its more rounded an not so restrictive.
 

·
Registered
Joined
·
322 Posts
this carb choke mod does nothing

dont waiste your time or money
 

·
Registered
Joined
·
62 Posts
fiddyonefiddy said:
this carb choke mod does nothing

dont waiste your time or money


Well supposedly it's supposed to cut down the turblence in the carb like a smooth bore... but i'm sure the only way to tell would be on an dyno and even then.. The damn carb was made to have a choke.. hehe.. What a pain in the ass.. "shit.. my bike won't start!" that's like reinventing the wheel. heheh.. Ahh fark it.. it's somthing to do when your a broke dick.. Jb weld is cheap.. heheh..
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top