PlanetMinis Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,975 Posts
Danman2540 said:
I was just wondering if I put another engine in my ST will I be able to wire the tach to still work off the new engine?


does the ST tach run off the 12 volt and a sensor on the coil lead? or is it run off the cam. ifs its a electrical tach it will be no problem to move it from one bike to the other. If its a cam driven tach then you will have to see if the head will support the same setup on the new motor.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top