[stlwalnut]

I have an odd stalling problem with my yx150 motored SSR. After a long straight at full throttle, I shut the throttle to down shift for a turn, and when I get back on the throttle, it bogs and stalls, like it's running out of gas. I cuss a little, coast to a stop, wait a few seconds, and while still cussing, kick it over. It starts up and runs fine for awhile, then the next long straight, it does it again...
The motor has one of those most excellent Molkt carbs on it. It also has a regular stator, not the IRK. If it's a fueling issue, does anyone know what the float height should be for a Molkt carb should be?

 

[Special~K]

I have an odd stalling problem with my yx150 motored SSR. After a long straight at full throttle, I shut the throttle to down shift for a turn, and when I get back on the throttle, it bogs and stalls, like it's running out of gas. I cuss a little, coast to a stop, wait a few seconds, and while still cussing, kick it over. It starts up and runs fine for awhile, then the next long straight, it does it again...
The motor has one of those most excellent Molkt carbs on it. It also has a regular stator, not the IRK. If it's a fueling issue, does anyone know what the float height should be for a Molkt carb should be?

Split the carb... turn it upside down and adjust float so that the float seam is level with the carb half.

 

[stlwalnut]

Thanks Special~K, I'll give anything a try at this point

 

[mr650tv]

had the same prob, its the carb take it off and put a vm26 carb on it from tbolt fixed it for me