PlanetMinis Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
I’ve got a 78 Xr75 And i installed a new kg clutch and I noticed that there is no torque specs on the clutch screws so I snugged them down just like everyone had told me to do. Put the cover back on and went to pull the clutch in and it just stops won’t let me pull it in. And then finally it breaks loose because inside the cover the clutch lifter that moves the actual clutch lever to engage the clutch skips over the the lever. And idk why!!! It’s driving me insane I’ve taken the cover off bent the tabs back and all messed with the tensioner screw and everything. The clutch worked after messing with it but took it for a rip down the street and it pops off!! Please help?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top