PlanetMinis Forums banner
1 - 6 of 6 Posts

· Registered
Joined
·
5,515 Posts
Discussion Starter · #1 ·
hey I am putting on my sano swingarm right now. when I got everything tightened up, there is play in the lower part of the swingarm....the bolt seems to be too small for the bushings in the arm. what should I do?
 

· Registered
Joined
·
1,995 Posts
Stock frame?

Billetware(sano) swingarm?



You can shim it with washers, just make sure that they are small enough to fit flush against the swingarm bearings. I got mine at Home Depot and the only ones I could find were made of brass.

I had the same problem (side to side wiggle) till I got a cromo frame.
 

· Registered
Joined
·
5,515 Posts
Discussion Starter · #3 ·
its more of a front to back wiggle. Its like the spacers in the swingarm have too big of a hole in the center. The shock mount seems to be off too. the shock doesnt go straight into the mount, its like 1/4 of an inch off, I have to move the shock over to get it in.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top