PlanetMinis Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2,150 Posts
Discussion Starter #1
So Im looking around for a 6 hole rotor. I was wondering is there a lot of difference between a 180 and a 200? I already have to have the bracket fabricated for this so that isnt the issue. Im wondering is the larger rotors tend to bend easily or are less likely to bend? if only galfer didnt charger $100 bucks for a rotor or if they made a 6 hole damn them
 

·
Registered
Joined
·
2,150 Posts
Discussion Starter #4
ya i found my rotor already ;) i just wanna make sure about the size difference before I order it. I should kept the one I traded you lol...btw you should used fedex that whole box i shipped you cost me $10 granted I have an account with them but still...well as soon as I get a front end ill post pics up. The rotor I picked out is like no one elses Ive seen on a mini. Didnt even know that I could get it. Just gotta fab my ktm nissin caliper now. still wondering if itll warp the rotor though.
 
1 - 4 of 4 Posts
Top