PlanetMinis Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
4,412 Posts
Discussion Starter · #1 ·
Reeg CRF 70. Billetware cradle frame Minus 3 degrees rake w/ custom crf50 Ultima Exhaust, 8 inch travel dual compression Zokes with Reeg Hub Excel rim dual piston caliper Cr 85 master cyclinder,line w/ asv lever,Cr 85 throttle,Renthal Carmichael mini bars, High and low speed compression Elka rear shock,Fastway Pegs(the good ones) Reeg rear disc set up with brand new pads w/excel rim aluminum axle spacers, 756 tires,Lowwer peg mount then the billetware one for better center of gravity, plastics great except some scratchs on front fender.

146 GPX motor w/ BRAND NEW Clutch basket and and plates,Crank,Tb cyclinder w/Akunar piston,BV Lifan Head ported by Cat5 with Brand New 28/24 valves and Z40 cam oil cooler tap w/kitaco oil cooler,port matched kitaco Long and short intake, VM 26 mm carb w uni pod filter.6oz Aluminum oil sling, AHP lightened flywheel.Engine never even started since new parts installed. and some other custom stuff.

I live in Michigan for Pick Up, you want it shipped you get it done. $4200 OBO you couldnt even build the chassis near that cheap. PM or email me at [email protected]









 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top