PlanetMinis Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
501 Posts
Discussion Starter #1
The piston on the rear master cylinder is stuck in the up position. Bike has never even been out of the yard yet, nor seen any mud. Has this happened to any one else? Is it fixable or should i just buy a new one? I just sold an extra one I had not even a week ago ARGGGGHHHHHHH!!!!!!!!
 

·
Registered
Joined
·
379 Posts
I haven't had any problems with mine. Have you taken it aprt to check it out? or just call up John or Bob they've been great taking care of any issues I've had with mine.
 

·
Registered
Joined
·
501 Posts
Discussion Starter #3
I have taken the master cylinder off of the frame. Looked at the bottom and the base of the piston is in the up position. I have also taken the top off to check the fluid level.

I wonder if pushing the caliper pistons in would do anything good? :confused:
 

·
Registered
Joined
·
328 Posts
How about we just send you a new one?



Call John... it is just no big deal with all the 100's of parts we have laying around.



bob - back from Spring Break/Mexico 2010!
 
1 - 4 of 4 Posts
Top