PlanetMinis Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
816 Posts
buy a rim lock and install it also when u put the new tube in dont put the nut on the valve stem all the way too the rim leave it above the rim like a quarter inch after u have air in it good luck had the same problems when i was tightening the nut all the way down to the rim on the valve stem so leave it above the rim a quarter inch tell us how it does but the best thing would be get a rim lock and drill ur rim and install and u will never have to worry again
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top