PlanetMinis Forums banner
1 - 15 of 15 Posts

· Registered
Joined
·
1,381 Posts
Discussion Starter · #3 ·
Thanks. Ya those might be a little low. Is there a happy medium between the klx bend and the crf bend? Why do those look so much lower than the xr bend? On the protaper site it says that the xr bend rise is 171mm and the klx rise is 143mm. Technically that's only about an inch difference. I need a bar that's right in between. Here's the site, tell me what you guys think. http://www.protaper.com/07/contents/products/handlebars/se.html
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top