PlanetMinis Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
2,542 Posts
Discussion Starter · #1 ·
I needed one bad so I called every place in the Minimoto/Dirtrider mags. Finaly found a place called wwwPMPsprockets.com They have the pattern on file and can make any tooth count,CNC aluminium,raw or anodized, and best of all it's only $33.00 +shipp!My 40 tooth will be cut tonight and shipped tomorrow($5.00 to N.J.)Their add was in the last minimoto phone#1-888-668-6432 Hope this helps.
 

·
Registered
Joined
·
2,094 Posts
sprocket specialist have been making them for almost a year now. If you did a search you would have known this
 

·
Registered
Joined
·
2,542 Posts
Discussion Starter · #3 ·
Did that, they said I needed to get permission from the original pattern supplier(who knows who that is)as per confidentiality laws!
 

·
Registered
Joined
·
2,542 Posts
Discussion Starter · #5 ·
The lady at sprocket specialist said I needed to get permission from the original pattern supplier, I even tried using the part # supplied in the thread! Thats why I choose www.PMPsprockets.com very simple and fast.
 

·
Registered
Joined
·
2,542 Posts
Discussion Starter · #6 ·
Well I recieved my new CNC aluminium 40T rear sprocket today and it sure is a lot nicer looking than I thought it would be for $33.00! It looks like the renthal big bike piece only shrunk down. If some one can upload the pics I can e-mail them to you.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top