PlanetMinis Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
375 Posts
Discussion Starter #1
will these forks bolt to a stock 110 frame and i am running a super pro rear end will it be level?
 

·
Registered
Joined
·
405 Posts
you have to have a spacer kit for the stem in order to make the 110 bearings fit it then it will bolt right on with just a few modifications to the steering stops
 

·
Registered
Joined
·
356 Posts
Use the pitster inner races, with 2, klx, upper, outer races. The top bearing sits on the thread of the stem but it works fine and I'm sure is cheaper than the bearing kits. Worked for me!
 

·
Registered
Joined
·
4,276 Posts
Pitster has bearings that will fit right in,, the pitster bearings have a different angle and the surface of the roller will not set flush with the KLX outer races, this then pushes the roller against the ineer and outer races on the rollers corners. while this seems to work, it does not spread the forces accross the race and bearing roller evenly.
 
1 - 8 of 8 Posts
Top