PlanetMinis Forums banner
Cancel

Pics of my crf 70 fork install and mod...

5615 Views 13 Replies 7 Participants Last post by  Z50R, 
deputyperk
here they are installed, i still need to fab up somthing for the brake cable.












now heres my one issue with these forks, and please if anyone has done this mod and shared the same experience please tell me. It appears that the brake tab on the forks barely sits in the grove on the drum brake assembley. and i mean barely. it does not move but just barely sits in there. even if i open it up more it can not sit in the tab anymore cause of the spacing on the drum assembley where the axle goes through.
See less See more
4
Reply
Save
Like
1 - 5 of 14 Posts
deputyperk
i was told shving the tab down or opening theslot was enough, it def donnt move.
Reply
Save
Like
deputyperk
even if i shaved the tab more, it would not sit in the slot more. look at the drum were it butts up against the fork were the axle slides in, theres no more room. can u guys get pics how your tab slides in the drum?
Reply
Save
Like
deputyperk
so your front brak drum sat just like mine in my pic?
Reply
Save
Like
deputyperk
wheel position is dead center perfect. not sure what spring your reffering to?
Reply
Save
Like
1 - 5 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
PlanetMinis Forums
PlanetMinis forum is the internet's largest mini bike community. View thousands of photos, event coverage, tips, tricks and performance mods.
Full Forum Listing
Explore Our Forums
CRF50 KLX110, DRZ110, TTR90 CRF50/CRF70 Parts For Sale Chinese/Import Minis - General Discussion Roost Area
Top