PlanetMinis Forums banner
1 - 11 of 11 Posts

·
Registered
Joined
·
564 Posts
Discussion Starter · #5 ·
I am running a Kitaco 143 right now, and no you don't. But to run the TB 165 you do have to bore the cases. The Kitaco 143 with the Pax 57.6 Stroker Crank is a Beast. Worth every penny of it. $175 is cheap. They retail at $350.
 

·
Registered
Joined
·
4,342 Posts
NOTE: You will need to have the inside of your cases relief cut (Or Bored rather) to except that crank into the cases. As the stroke gets bigger the pin placement gets further from center or rather toward the outside of the crank. this cranks pin placement for the rod is toward the outside of the crank and therefore the rod sticks out and would hit the inside parts of the case if not bored.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top