PlanetMinis Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
xy150, 170bbk, v2 head, fmf 4.1



Anyone have this setup? I'm looking for a stating point to jet the carb.

main jet, pilot jet and needle clip position?



This is an 08 Pitster X4R.



Or is this enough carb for the motor?



Thanks
 

·
Registered
Joined
·
581 Posts
eflbiker said:
xy150, 170bbk, v2 head, fmf 4.1



Anyone have this setup? I'm looking for a stating point to jet the carb.

main jet, pilot jet and needle clip position?



This is an 08 Pitster X4R.



Or is this enough carb for the motor?



Thanks


I dont know personaly sorry... But when you do get that thing tuned in, its going rip!!! Lucky!! I want the V2 head. I have the 170BBK on my YX and i just ordered a genuine KEIHIN PWK 28mm. Now like said i need to get that head, i just need to man up and fork over the $$$ to buy it. Sweet man good luck on that.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top