check the four nuts on the front of the head, one should have a copper washer under it. The copper washer should be on the left bottom with respect to the seat position.
Oil leak in head??
So, i recently rebuilt my (50) motor, but now that i have my head back on it has a pretty decent oil leak, i cant tell where its coming from so any suggestions would be nice thanks
1 - 6 of 6 Posts
That seemed to fix the problem, i had the washer on the bottom right head bolt.
Thanks:biglaugh:
Thanks:biglaugh:
isnt the copper washer supposed to be on the oil passage stud? if you are sitting on the seat that is right bottom
Z50King said:isnt the copper washer supposed to be on the oil passage stud? if you are sitting on the seat that is right bottom
My bad, you're correct; bottom right while on the seat. The remaining three are discribed as 'sealing' washers.
Ya thats right because it was bottom left facing the bike
1 - 6 of 6 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
PlanetMinis Forums
PlanetMinis forum is the internet's largest mini bike community. View thousands of photos, event coverage, tips, tricks and performance mods.
Full Forum Listing
