PlanetMinis Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi,
I am looking at buying the Wiseco piston kit 0.20 oversize. Will this require the cylinder to be bored or honed? I haven’t torn into the top end yet but assume it is running the stock piston. Will that kit work.
Thanks.
 

·
Registered
Joined
·
4,085 Posts
Buy the oversized piston, take it to a local machinist and have them bore your stock cylinder. If you don't want to bore anything, buy an OEM piston/cylinder or an aftermarket bore kit and it will bolt right up.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top