PlanetMinis Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
252 Posts
Discussion Starter · #1 ·
Can I use any aftermarket heads, pistons, or cylinders on a cr107 motor? Also, can I use any aftermarket carb?
 
G

·
yes Classic makes a 54mm piston kit for the cr107 and you should run a 24mm carb to get the power you want



If you need help we can get it for you
 

·
Registered
Joined
·
252 Posts
Discussion Starter · #3 ·
Cool, thanks. I just wanted to know because i'll probably be buying a 107 from a friend for $500. Are the cases pre-bored to 54mm? I was planning on using the 24mm flat-slide carb, it seems like it would be a good match.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top