PlanetMinis Forums banner
1 - 1 of 3 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
hi i have a motor as below

tb 88 kit and tb head, and a tb manual clutch, shaved flywheel.

i am thinking of adding a crank and close ratio gear kit, but what crank will work with the cylinder and head i have allready (tb). i have only seen them in kits with a cylinder and i dont need another one!!

what are your recomendations, and would it be better with my shaved flywheel or a inner rotor.

help me please
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.