PlanetMinis Forums banner
21 - 40 of 40 Posts

·
Registered
Joined
·
327 Posts
Discussion Starter · #23 ·
the rear bearing are fully seated but the center piece is not tight.
I may have been shipped the wrong piece, as it is loose.
As far as I know it needs to be tight to keep the lower bearing race in line with the top.

I have a stock one.
Will probably knock it out tomorrow and see if my stock one will work right.
 

·
Registered
Joined
·
327 Posts
Discussion Starter · #25 ·
still waiting on the tank to do the next powder coat run.
tank, footpegs, rear brake pedal, rear shock spring satin black.
Might leave the shock spring as is, I don't hate it..
 

·
Registered
Joined
·
327 Posts
Discussion Starter · #28 ·
What do people run on their Daytonas? the CDI that come with it?
Do I run it on the lowest settings?
Don't want to hurt it..
Can I run my Takegawa hyper CDI?
 

·
Registered
Joined
·
327 Posts
Discussion Starter · #29 ·
I will get pictures tomorrow. Meant to take them tonight. I put a chain 110 length, on (
I took 10 lengths off ).
And the TRX90 side cover with pull start. With the decomp cam, it pulls like butter, two fingers..
 

·
Registered
Joined
·
598 Posts
The green frame with carbon body will be dope.
Your white trike looks great with the round headlight also!

I did the old hole saw trick on the trx90 recoil cover on one of mine. Much easier to hack up a used cover then a minty fresh one though.



Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
327 Posts
Discussion Starter · #36 ·
Not a bad Idea, cleans it up a lot..
I have hole saws, a band saw and a dremel.
Pretty sure I could make this happen...
 

·
Registered
Joined
·
327 Posts
Discussion Starter · #37 ·
Tank is supposed to get here next week.
Then final round of powder coat. and clean up some wiring.
Add a light to the front.
 
21 - 40 of 40 Posts
Top